Comware

I have a 1920-16g switch and I want to configure it for routing my network.

I have a plc with ethernet and I have a other network device.

My PLC ip address is:192.168.1.71 255.255.255.0

      other device ip is: 192.168.100.100 255.255.0.0

and I dont have a gateway device. How I configure my hpe?

Hi

First of all your client needs a gateway if you want to route between vlans. 

And second, the 1920 switch is not a routing switch. The only thing it supports is static routes.

Kind regards

For sure the 1920 is a routing switch, since  it can route among VLANs and to static routes, whereas a layer 2 switch can only switch packets onto the .

If you hack yourself into the CLI.....you'll find as an undocumented feature both ripv2 and ospf routing protocols.

thank you for your reply.

I will try but I'm beginer for this topic.

@16again Like i said it only supports static routes. I'm pretty sure that ospf will not be possible on this type of switch, even in the CLI.

Kind regards

I'm also pretty sure....seeing is believing:  (for the ospf commands, just look into H3C S-5500-SI_Manual_V1.03.pdf  and try on 1920)

[hp1920]display ospf peer

                  OSPF Process 100 with Router ID 0.0.19.20
                        Neighbor Brief Information

 Area: 0.0.0.0
 Router ID       Address         Pri  Dead-Time  Interface       State
 10.31.76.249    10.31.76.249    1    34         Vlan333         Full/BDR
[HP1920]display ip routing-table
Routing Tables: Public
        Destinations : 15       Routes : 15

Destination/Mask    Proto  Pre  Cost         NextHop         Interface

0.0.0.0/0           Static 1    0            10.31.76.253    Vlan333
10.0.0.0/8          OSPF   110  21           10.31.76.249    Vlan333
10.31.76.0/26       Direct 0    0            10.31.76.62     Vlan330
10.31.76.62/32      Direct 0    0            127.0.0.1       InLoop0
10.31.76.64/26      Direct 0    0            10.31.76.126    Vlan331
10.31.76.126/32     Direct 0    0            127.0.0.1       InLoop0
10.31.76.128/27     Direct 0    0            10.31.76.158    Vlan332
10.31.76.158/32     Direct 0    0            127.0.0.1       InLoop0
10.31.76.192/26     Direct 0    0            10.31.76.254    Vlan333
10.31.76.254/32     Direct 0    0            127.0.0.1       InLoop0
127.0.0.0/8         Direct 0    0            127.0.0.1       InLoop0
127.0.0.1/32        Direct 0    0            127.0.0.1       InLoop0
172.16.0.0/12       OSPF   110  21           10.31.76.249    Vlan333
172.30.121.0/24     O_ASE  110  41           10.31.76.249    Vlan333
192.168.0.0/16      O_ASE  110  20           10.31.76.249    Vlan333

tahank you for your interest, I solved the problem. It's working now and dont need a default gateway.