Hi,
I've got a pair of 7205 controllers in active / standby with no mobility master (running 8.7.0)
In test I have two SSIDs, one tunnel and one bridge mode. The bridge mode is using the native vlan of switch the ap is plugged into. I have updated AP-System profile of the AP group to the correct vlan.
This results in clients being able to connect to the bridge SSID after some time, they get an ip on the correct vlan from the dhcp server, however they cannot pass any traffic (pings to ap / gateway / internet).
when I check the user table I see an ipv6 and an ipv4 entry (ipv6 is globally disabled). If I run through the guide below and delete any aaa users It works perfectly, until the next morning where I need to fiddle and do the same to get it working again?
https://community.arubanetworks.com/t5/Controller-Based-WLANs/IPV6-entries-for-Bridge-mode-users-in-user-table-even-with-IPV6/ta-p/655611
Has anyone else come across this and managed to solve - also annoyingly even after carrying out the instructions above I still get an ipv6 user entry as well as ipv4.