Hi
One of my 500 ap's seems to have a problem by booting.
Resetting the ap with the console does not seem to fix it.
The Checksum bad keeps going, and never stops.
Running 6.5.1.9 in a mixed envirment of ap-105, 205 and 305 on a master controller: 7010
Does any one have an idee what I can do? Exept from "open a TAC case"
apboot>
APBoot 1.2.4.4 (build 26618)
Built: 2011-01-07 at 13:42:04
Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1
Hit <Enter> to stop autoboot: 0
Checking image @ 0xbf100000
Invalid image format version: 0xffffffff
Checking image @ 0xbf800000
Invalid image format version: 0xffffffff
eth0 up: 1 Gb/s full duplex
DHCP broadcast 1
DHCP IP address: 10.208.51.138
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 10.208.51.1
DHCP DNS server: 10.205.8.50
DHCP DNS domain: *****.******
ADP multicast 1
checksum bad
ADP broadcast 1
ADP multicast 2
ADP broadcast 2
ADP multicast 3
Retry count exceeded
DNS request 1 for aruba-master.****.***** to 10.205.8.50
T Using eth0 device
TFTP from server 10.206.80.10; our IP address is 10.208.51.138; sending through gateway 10.208.51.1
Filename 'mips32.ari'.
Load address: 0x2000000
Loading: T T T T T #T T T T T T T T T T T T T T T T T T T T T T T T T
Retry count exceeded; starting again
eth0 up: 1 Gb/s full duplex
checksum bad
checksum bad
checksum bad
checksum bad
checksum bad
checksum bad
checksum bad