Wireless Access

 View Only

  • 1.  AP 505

    Posted Feb 14, 2024 12:39 PM 
    Hello, we have some Aps 505, using a 7210 controller, however some Aps are no longer on the controller, but have a fixed IP and the ICMP test is ok, but I can enter root mode on the AP via the network, but I cannot perform the reset. factory, any tips?


  • 2.  RE: AP 505

    Posted Feb 14, 2024 01:35 PM

    If you have physical access to the AP you can reset them to factory default by press and hold the reset button for 10 seconding when power on the AP.



    ------------------------------
    Marcel Koedijk | MVP Expert 2023 | ACEP | ACMP | ACCP | ACDP | Ekahau ECSE | Not an HPE Employee | Opinions are my own
    ------------------------------



  • 3.  RE: AP 505

    Posted Feb 14, 2024 03:02 PM 
    One of the Aps that was low, I did this procedure and reconfigured it and it worked, but the others are high, the most viable would be a remote command, via the network I can log into them via root, but I couldn't find any command to perform the reset to factory, just reboot.

    Original Message


Related Content