Wireless Access

Hello,

I need to setup manually the controller IP address on a brand new AP.
For several reasons I don't want to use DNS, DHCP etc..
Is there a guide that explains all the steps for GUI and the CLI?

Thanks

Giuseppe

Instant APs are designed around using DHCP for ease of use.  To set static ip addresses, you would need a console cable and use setenv commands here:  https://www.arubanetworks.com/techdocs/ArubaOS_65x_WebHelp/Content/ArubaFrameStyles/AP_Config/AP_Console_Settings.htm

------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
------------------------------

Hello cjoseph,

Thanks a lot!
Original Message:
Sent: Sep 02, 2022 05:08 AM
From: Colin Joseph
Subject: AP 515 - complete CLI and GUI guide for 8.X

Instant APs are designed around using DHCP for ease of use.  To set static ip addresses, you would need a console cable and use setenv commands here:  https://www.arubanetworks.com/techdocs/ArubaOS_65x_WebHelp/Content/ArubaFrameStyles/AP_Config/AP_Console_Settings.htm

------------------------------
Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
------------------------------