Wireless Access

 View Only

  • 1.  AP-575-US unable to add to web interface

    Posted Feb 02, 2026 11:02 AM

    New to this. Just picked up a couple of used AP-575-US to replace a bad AP outside my home. I can not add these with the web portal. It just keeps searching and doesn't find anything. It shows up in the Wi-Fi networks as "SetMeUp-CD.49.70"  and I can access it through the IP of the AP. I have reset it manually and still no access in the web portal.

    My main goal here is to set up the access point with a new name and WPA3 security. i do not see any type of options for that through the direct IP access. The firmware is "8.13.1.1_94375 LSR (Digitally Signed - Production Build)" I tried to upgrade the firmware though the automatic button but it comes back as  "image_check_internal error 001 code 2" 

    I'm at a loss at this moment. Anything will help



    ------------------------------
    Ralph
    ------------------------------


  • 2.  RE: AP-575-US unable to add to web interface

    Posted Feb 02, 2026 08:08 PM

    so if you have factory defaulted the AP and the fact that it is broadcasting setmeup SSID, that means it is operating as an Instant AP. So you need to connect to that WLAN and using your browser, it will redirect you to the WebUI of the AP. The credentials are admin and the serial number for the password. were you able to get this far?



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------



  • 3.  RE: AP-575-US unable to add to web interface

    Posted Feb 12, 2026 01:40 AM
    I did finally get it set up correctly. Took a little bit more work than I thought.
    Thank you.



    Original Message


Related Content