Controllerless Networks

 View Only
Back to discussions
Expand all | Collapse all

Aruba AP 514 - SSH command for showing network speed

This thread has been viewed 6 times

  • 1.  Aruba AP 514 - SSH command for showing network speed

    Posted Jul 14, 2025 07:32 AM

    Hi,

    were using about 30 AP 514/515 in our network.

    Now i want to know which command on each AP shows the network speed which has been handed out with the switch port.

    When I connect via SSH i can get:

    AP-AR15-H01-3.V.01.107# show wired-port-settings

Wired Port Profiles
-------------------
Name                        VLAN Mode  Allowed VLANs  Native VLAN  Admin Status  Role                        Speed  Duplex  POE  In Use  Authentication Method  STP  Trusted
----                        ---------  -------------  -----------  ------------  ----                        -----  ------  ---  ------  ---------------------  ---  -------
wired-SetMeUp               Access     all            guest        Up            wired-SetMeUp               auto   auto    No   Yes     None                   No   No
default_wired_port_profile  Trunk      all            1            Down          default_wired_port_profile  auto   full    No   Yes     None                   No   No


    or:

    AP-AR15-H01-3.V.01.107# show port status

Port Status
-----------
Port  Type   Admin-State  Oper-State  STP-State  Dot3az   Loop-Protect  Storm-Control  Loop-Detection-TX  Loop-Detection-RX
----  ----   -----------  ----------  ---------  ------   ------------  -------------  -----------------  -----------------
eth0  2.5GE  up           up          N/A        Disable  OFF           OFF            0                  0
eth1  GE     up           down        N/A        Disable  OFF           OFF            0                  0
eth2  USB    up           down        N/A        Disable  OFF           OFF            0                  0
AP-AR15-H01-3.V.01.107#


    But there is not shown if the port is connected with 10/100/1000/2500 ?

    Please help here, Thanks



  • 2.  RE: Aruba AP 514 - SSH command for showing network speed

    Posted Jul 14, 2025 07:34 AM 
    AP735-S# show interface
eth0 is up, line protocol is up
Hardware is 5 Gigabit Ethernet, address is 98:8f:00:12:28:a3
Speed 1000Mb/s, duplex full
Received packets                 81711044
Received bytes                   48488647090
Receive dropped                  0
Receive errors                   0
Receive missed errors            0


    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------

    Original Message


Related Content