Controllerless Networks

 View Only
Back to discussions
Expand all | Collapse all

Assigning wired network profiles in virtual controller

This thread has been viewed 13 times

  • 1.  Assigning wired network profiles in virtual controller

    Posted Feb 28, 2022 03:19 PM
    Hi

    I have 4 APs. A VLAN trunk to each on eth0 with PoE power. Works perfect.

    Now.. I wanted to take out VLAN 21 on one of the APs eth1 port. I created a wired profile "Printer_network" put it as an "access" for VLAN 21 and in assignment tied it to "0/1" Then the eth1 port on the AP worked as an access port on VLAN 21. Good...

    Now to my question. As the assignment is done globally, is there no way to assign different profiles to different eth1 ports on different APs. It seems my assignment will make all eth1 ports on all APs a vlan 21 access port. Let's say I want eth1 on another AP to not have the same profile. That seems impossible as the assignment cannot be done on per AP basis, but only globally for the whole IAP cluster.

    Cannot find anything about this anywhere in the Aruba docs.

    Am I missing something?

    Tnx in advance
    //Peo

    ------------------------------
    Per-Olov Sj�holm
    ------------------------------


  • 2.  RE: Assigning wired network profiles in virtual controller
    Best Answer

    Posted Mar 02, 2022 12:41 AM
    when you apply wired profiles, it gets applied to the whole cluster. so it is global.

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba.
    ------------------------------



Related Content