Wireless Access

 View Only

  • 1.  Captive Portal Configuration

    Posted Jul 27, 2023 05:15 PM

    Hi Team,

    I hope you are all doing well!

    I was looking for documentation or guides on how to configure a Captive Portal using an Aruba Mobility Controller on version 6.5.

    I have found the section on the documentation page here (ArubaOS 6.5.0.x User Guide & CLI Reference Guide) , however I'm missing a guide on how to configure it without user authentication. See, I want to configure guest authentication (no username/password, just accept the terms and connect) but I cannot find a guide specific for tho's needs.

    Also, when I check out the default portal, I can only see a couple of buttons in the default portal page. There is only a field for username and password but when I want anonymous authentication I of course don't want the option to fill in username/password to appear.

    Can any of you maybe guide me trough the proces of share documentation with me for my needs?

    Thank you in advance,

    With best regards,

    Alvaro



  • 2.  RE: Captive Portal Configuration

    Posted Jul 27, 2023 09:53 PM
    Edited by ariyap Jul 27, 2023 09:53 PM

    firmware 6.5 is fairly old. but see if this video helps

    https://www.youtube.com/watch?v=3jQovV9f9K8



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 3.  RE: Captive Portal Configuration

    Posted Jul 28, 2023 04:12 AM

    Hi Ariyap,

    Thank you for your reply. The video shown configures (I think) a Captive Portal for login via username/password. I am looking for a configuration where the user does not need to login. The user only accepts the terms and clicks connect. No username/password.

    Is there maybe a version of ArubaOS where there is documentation on this? Maybe I can upgrade to that version then.

    Thank you


    Original Message


  • 4.  RE: Captive Portal Configuration
    Best Answer

    Posted Jul 28, 2023 08:49 AM

    You need to go to Configuration> Security> Authentication> L2 Authentication.  Select your Captive Portal authentication profile.  Make sure that Guest Login and User Login is unchecked.  Also make sure that "show acceptable use policy page" is checked:



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


Related Content