Network Management

Hi you all.

I have IMC 7.0 and most of my switches are cisco 2960.

im able to backup and monitor all of my switches,

but i didnt understood how to configure a cisco switch via the IMC.

for example :

i need to add that line to all of my ciscos :

"logging 1.1.1.1"

can any one give me the exact commands and Response Prompt that i should add to the configuration templates on the IMC ?

I wouldn't worry too much about response prompts, etc.

You can just do:

conf t

logging 1.1.1.1

exit

And then select the option to save the config.

Response prompts are useful if you need to check specific output, but for a one-line change I wouldn't be too worried about it.

If you've got SNMP read-write access, you could just deploy as a segment, in which case you only need "logging 1.1.1.1"

can you upload the document to cofigure cisco devices to integrate with IMC v7.0

There's no specific document. Adding new devices is covered in the Admin Guide. The process is the same for both Cisco & HP devices.