Developer

 View Only

  • 1.  CNX and PTP configurations through API...

    Posted Jun 28, 2026 06:13 AM

    Hello,

    There is still no UI to create PTP configurations to switches, I found "half-way" to do it through API (Create or Update existing PTP Profile instance configurations) which can be used to create  proper profile to device groups.
    Other half of success which still missing is that I don't know how to attach proper configuration line ("ptp enable") to interface?

    I would rather user SW Port profile (/network-config/v1alpha1/sw-port-profiles) because it's easy to use by non-technical common users and it seems to hold also /network-config/v1alpha1/ethernet-interfaces configurations where there is also ptp interface configurations.

    While waiting to get "PTP: enable" configuration to CNX port profile UI is there any way to insert "ptp enable" configuration to SW Port profile?



    ------------------------------
    Regards
    -Jori Luoto-
    AV-IT networking
    ------------------------------


  • 2.  RE: CNX and PTP configurations through API...

    Posted Jul 01, 2026 09:05 AM

    Hi Jori,

    Do you have found ? do you have ask your local SE ?



    ------------------------------
    PowerArubaSW : Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP...

    PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...)

    PowerArubaCL: Powershell Module to use Aruba Central

    PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)..

    ACEP / ACMX #107 / ACDX #1281
    ------------------------------



  • 3.  RE: CNX and PTP configurations through API...

    Posted Jul 01, 2026 09:20 AM

    Hello,

    Nope!
    In Finland we have summer vacation season going on and I think local SE did not have time to dig this case profoundly.

    Found system to create proper ptp profile to switches through CNX API but now I'm stuck with one single configuration per port which is needed to run ptp transparent against packets. It seems that from CLI in Aruba Support mode I can add "ptp enable" directly to switch port and it stays there until port configuration is changed.



    ------------------------------
    Regards
    -Jori Luoto-
    AV-IT networking
    ------------------------------

    Original Message


  • 4.  RE: CNX and PTP configurations through API...

    Posted Jul 02, 2026 11:11 AM

    I was wrong about presistence of cli config... It seemed that "ptp. enable" was removed after CNX configuration refresh.



    ------------------------------
    Regards
    -Jori Luoto-
    AV-IT networking
    ------------------------------

    Original Message


Related Content