Comware

 View Only
Back to discussions
Expand all | Collapse all

Connection between ProCurve 2810-24G and ProCurve 2610-24

This thread has been viewed 0 times

  • 1.  Connection between ProCurve 2810-24G and ProCurve 2610-24

    Posted Nov 24, 2010 08:55 AM

    I have a system with two switches ProCurve J9021A - 2810-24G and other seven peripherals switches ProCurve J9085A - 2610-24.

    The peripherals are linked in the MiniGBic ports of the two main switches, but I have no network connection from the center to the peripherals.

    Did someone find problems with this type of connection?

    I have to say that the firmware on board is not the latest one, I'm going to update it on all of them but I will be granted to know that a new firmware can be the solution (the system is abroad and I'm going to travel there)

     

    Tnx in advance

    Luca



  • 2.  RE: Connection between ProCurve 2810-24G and ProCurve 2610-24

    Posted Jan 07, 2011 02:05 AM

    These are traditional ProCurve switches, and should really be in the E-Series section.

     

    Things to check:

     

    • Only ProCurve SFP/optics are supported.
    • The SFP ports are dual personality - cannot have a network cable plugged in to the same numbered port.
    • Do you have any VLANs? Make sure the ports are in the same VLANs or you have trunking an routing sorted out properly.

     



Related Content