Cloud Managed Networks

Hi Team,

I am new to managing switches with Aruba Central and cannot find the option for disabling switchports. The 2930F is managed in a group with a template assigned. This is in Sync.

Any advice would be welcome.

------------------------------
Matthew McDonald
------------------------------

Hi Matthew,

did you ever get an answer or find out ?

I would like to know how to enable a port again if it did get disable by loop-protect feature and a manual action is required to get the port enabled again.

The config should not differ (between template and switch-running) - and I guess as switch is managed by Central it's not possible to do via CLI directly.

Groetjes

Jochem

------------------------------
Jochem Knoben
------------------------------

You can do it from switch cli via ssh or from Central Console feature.

Go into config mode and enable aruba-central support mode:

# configure terminal
(config)# aruba-central support-mode enable

After you finish just disable support-mode

(config)# aruba-central support-mode disable

Best, Gorazd

​​

------------------------------
Gorazd Kikelj
------------------------------

Thanx Gorazd,

I hope Aruba will add some different possibility to do so in the future.

Groetjes

Jochem

------------------------------
Jochem Knoben
------------------------------

Original Message:
Sent: Dec 04, 2021 02:55 AM
From: Gorazd Kikelj
Subject: Disable Switch Port Interface from Aruba Central Cloud

You can do it from switch cli via ssh or from Central Console feature.

Go into config mode and enable aruba-central support mode:

# configure terminal
(config)# aruba-central support-mode enable

After you finish just disable support-mode

(config)# aruba-central support-mode disable

Best, Gorazd

​​

------------------------------
Gorazd Kikelj
------------------------------