Wired Intelligent Edge

Hi,

I have 2 core E8212zl, and i using the VRRP's redondance, for all vlan except the vlan 145 and vlan 1.

In my LAN i have 2 Ucopia's server (for the visitor's internet access), and both Ucopia's server use also the VRRP protocol for their redundancy management, and their Ucopia's server are vlan 145 member and use this vlan for the redundancy management's traffic.

Everything works well. No problem.

But in the event log of the 2 core i'have every time this event:  "vrrp: AM1: No VR with IPv4 vrid 1 found on vid 145(6750089)".

I does'nt configured VRRP for vlan 1 and vlan 145 in the 2 core.

How i can disable this event in the log listing of the 2 core?

Thanks.

i am about to put the same setup for my e5406zl switches.

so i following along :)

have you put VLAN1 and 145 in the VRRP setup at all ?

you could try to let the core SW to just be primary for the 2 VLANs.

are you using VLAN1?

why whci switch is running VLAN 145 ?

post your config file here at thread - would be a good idea.