Wired Intelligent Edge

Hi,

Anyone know the reason for this strange behavior?

This interface doesn't have anything connected to it. Also tried with administrative shut. Yet, the TX input errors and drops keep increasing.

Interface 1/1/2 is down
 Admin state is up
 State information: Waiting for link
 Link transitions: 0
 Description:
 Hardware: Ethernet, MAC Address: 10:4f:58:xx:xx:xx
 MTU 1500
 Type 5G-SmartRate
 Full-duplex
 qos trust none
 Speed 0 Mb/s
 Auto-negotiation is on
 Flow-control: off
 Error-control: off
 MDI mode: none
 VLAN Mode: access
 Access VLAN: 1
 Rx
             0 input packets               0 bytes
             0 input error                 0 dropped
             0 CRC/FCS
 Tx
             0 output packets              0 bytes
         13006 input error             13006 dropped
             0 collision

To make it clear, I reset the counters and nothing is ever connected to it afterwards. But after some short seconds,the input errors and drop count start showing the errors.

This is a 6300M by the way.

Regards

Hello,

Hoping Aruba 6300 is loaded with latest image 10.04.0030 (Command: show version)?

Thank you,

Yash

It's apparently similar (but not equal) to CR 71114 "Counters" solved on ArubaOS-CX 10.04.0030:

Symptom/Scenario: Drop counters for Rx increase when running the show interface command.

OP is actually seeing increasing collisions/drops on Tx instead...and with interface administratively shutted down too!

i already get the same typo of issue with 8320... (but not yet fixed for me)