Wired Intelligent Edge

I have several 2900-48g switches, some of which display fault-finder lines in the config, and some of which don't.

The firmware is identical for all of them.

The lines in the switches where "fault-finder" appears are all prefixed with "no".

I don't want fault-finder enabled.

How do I stop the fault-finder lines from showing in the config ?

---

Joshua Kaplan_1 wrote: The lines in the switches where "fault-finder" appears are all prefixed with "no". I don't want fault-finder enabled.

Exactly, no fault-finder means probably "don't log Fault-Finder related messages"...if you don't want fault-finder to be enabled then no fault-finder is the way to go.

How do I stop the fault-finder lines from showing in the config ?

---

That's in contrast with the request above...if you don't want it enabled then the no fault-finder directive is necessary (AFAIK)...so you can't then trash that directive from configuration and pretend to have that feature disabled (since it seems enabled by default). Isn't it?

" no fault-finder" results in "incomplete input: fault-finder"

I'm afraid that won't do it.

adding a question mark only shows the subparameters available, none of which disable the feature.