Good Day,
Thank you for the reply.
Among a lot of "stand alone" switches we have the following Core switch setup, all four switches are stacked, one 16porter as the commander two others are members and one standby.
Aruba 3810M-16SFP+-2-slot Switch (JL075A)
1 Commander & One Member
Aruba JL074A 3810M-48G-PoE+-1-slot Switch (JL074A)
1 Member & One Standby
If I use the GUI (HTTP) to do the firmware upgrade, I will upload the latest Firmware (KB_16_11_0020.swi) to the Secondary Image, then reboot & confirm the secondary image is uploaded then rinse and repeat on the Primary Image?
Last question am I correct in assuming the Commander will copy the uploading Firmware, Both Secondary & Primary to all the members including the standby?
As always feedback will be apricated
Regards
Heinrich Gessner | Networking Managed Services Engineer (L2) heinrich.gessner@global.ntt | m. +27 83 6428762 | o. +27 11 5757143 | NTT DATA | services.global.ntt Dimension Data an NTT DATA, Inc. company This email and all contents are subject to the following disclaimer:
https://services.global.ntt/en-us/email-disclaimer
Sensitivity Label: General
Original Message:
Sent: 9/20/2024 7:55:00 PM
From: ariyap
Subject: RE: Firmware Upgrades to Latest
you can get the firmware from HPE Networking support Portal
The latest one is 16.11.0020
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------