Comware

 View Only
Back to discussions
Expand all | Collapse all

GbE2c blade switch management interface

This thread has been viewed 0 times

  • 1.  GbE2c blade switch management interface

    Posted Nov 19, 2010 10:40 AM
    I am trying to use image2 in the switch to try some new settings, but i am unable to get image2 working right.

    Image2 was at version 2.0.0 so i upgraded it to 2.0.4 and then to 5.1.3. It boots fine, but for some reason the management interface is not present on image2.

    I ask display info about layer 3 settings and it shows no interfaces. I tried to setup interface 256, but it fails when i try to add it to the management VLAN 4095.

    Any ideas on how i can configure the management interface..?

    Thanks


Related Content