Hello, I have a trouble with configure Dynamic LAG between
HP 1910-28G and linux 3.11.0-15-generic #25~precise1-Ubuntu SMP Thu Jan 30 17:39:31 UTC 2014 x86_64 x86_64 x86_64 GNU/Linux
When i create new Dynamic LAG the linux host become unreachable.
On Web UI: LAG state: Reason for being Unselected. The port is not configured properly.
LACP screenshot https://www.dropbox.com/s/qs4yf5ml4fvkp0l/lacp.png
cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2 (0)
MII Status: up
MII Polling Interval (ms): 50
Up Delay (ms): 0
Down Delay (ms): 0
802.3ad info
LACP rate: slow
Min links: 0
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 1
Actor Key: 17
Partner Key: 1
Partner Mac Address: 00:00:00:00:00:00
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:17:08:5a:d7:0f
Aggregator ID: 1
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:17:08:5a:d7:0e
Aggregator ID: 2
Slave queue ID: 0
It's possible to connect Linux and HP 1910 with 802.3ad?
P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. -HP Forum Moderator