Wired Intelligent Edge

We have several HP2910AL-24G switches which we need to log into. The admin password is lost. I understand that pressing the, "Clear", button for 10 seconds will remove the password info. Will this also clear the web login password, or just by the command line?

THanks:

Ed

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum moderator

Hi,

Yes It will Remove/ Clear all the Passwords.

Please find the artilce to reset Password:

http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=1827680&docId=emr_na-c02597105&docLocale=en_US

Hello,

When the “Clear” button is pressed with the “Reset” button, any configuration changes you may have made through the switch console, the web browser interface, and SNMP management are removed, and the factory default configuration is restored to the switch.

Specific steps to execute the factory default reset on the switch are:

1. Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on the front of the switch.

2. Continue to press the Clear button while releasing the Reset button.

3. When all three Mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear button.

The switch will then complete its self test and begin operating with its configuration restored to the factory default settings.

Note: After completing this procedure, there will be no password, the IP address will be returned to the default 192.168.2.10, and all configuration settings will be returned to factory defaults.

Thanks and regards

Anurag T

adding to the previous post. 

following article will help configuring switch or setting up password from console

http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c01844405

Regards,

Ali