Comware

Hi everyone maybe can someone help .

I have been trying to apply qos  between two sites with HP FLEXFABRIC 5950 .

MY priority is Video streaming over best effort with pseoduwire l2vpn between the sites.

Each l2vpn - vsi -service instance is a source .

I managed to configure DSCP CS4 ,Best effort in the lab whereby i am priroritizing the video DSCP

I understand that  DSCP works in the L3 layer ,

Does anyone know if i can priorities the video in the MPLS L2 HEADING with EX bits ?

Seems i connot apply remark mpls-exp or apply IF-MATCH MPLS-EXP ?

Does HP 5950 support MPLS QOS EX configuration with priority to certain traffic ?

Hi Alon,

From QOS configuration guide, i don't see  "remark mpls-exp or apply IF-MATCH MPLS-EXP" is supported

https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=1009514819&docLocale=en_US&docId=emr_na-a00037762en_us&withFrame

I verified from currrent Firmware Version 5950_7.10.R6205P03 for any new feature from release notes but none

https://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-a00038185en_us-4.pdf

Checked on device itself it doesn't have the command/feature supported

[HPE]display version
HPE Comware Software, Version 7.1.070, Release 6205P03

[HPE-behavior-11]remark ?
customer-vlan-id Remark customer VLAN ID
dot1p Remark 802.1p priority
drop-precedence Remark drop precedence
dscp Remark DSCP
green Specify green packets
ip-precedence Remark IP precedence
local-precedence Remark local precedence
qos-local-id Remark QoS local ID
red Specify red packets
service-vlan-id Remark service VLAN ID
yellow Specify yellow packets

[HPE-classifier-class1]if-match ?
acl Specify ACL to match
any Specify any packets to match
control-plane Specify control plane pre-defined matching rule
customer-dot1p Specify customer 802.1p priority to match
customer-vlan-id Specify customer VLAN ID to match
destination-mac Specify destination MAC address to match
dscp Specify DSCP to match
ip-precedence Specify IP precedence to match
protocol Specify protocol to match
qos-local-id Specify QoS local ID to match
service-dot1p Specify service 802.1p priority to match
service-vlan-id Specify service VLAN ID to match
source-mac Specify source MAC address to match
traffic-type Specify a traffic type to match
tunnel-id Specify tunnel ID to match
vxlan Specify a VXLAN ID to match

 

Hi thanks for the reply ,
So what i undestand that it is not suuported , Do you know maybe from wich hardware swithes it is supported ..i saw that maybe in the 12000 hardware it is ..

Yes Alon,

12500 Doses support, please refer command reference guide below.

https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c03595153 

Hope I have answered Your Query.