Im running in to an issue where if I check for no ip address under a vlan config using config segment checking in compliance check I get violations yet if I check the backup running config and startup the proper no ip address is there and if I test policy in compliance center I get proper result. I cannot figure out why compliance check would still give a violation. This is a very simple check.. as follows
Vlan 1 No IP Address
Config Segment Check
Starting Identifier = vlan 1
Ending Identifier = exit
Check for Strict Pattern
no ip address
90% of devices show properly but that 10% shows a violation and there isnt.
Thank you for any assistance!
------------------------------
David Hagar
------------------------------