Wired Intelligent Edge

Hello I don't know how to work route between VLans. I hope you help me. I have that two ports (A2-A3 ) and not have ping between both, and both must go out to internet by 192.168.3.2 I have this configuration. Thank you very much. Running configuration: ; J8773A Configuration Editor; Created on release #L.11.20 hostname "ProCurve Switch 4208vl" snmp-server location "CPD" web-management support-url "http://192.168.3.15" time daylight-time-rule Middle-Europe-and-Portugal module 1 type J8768A module 3 type J8768A module 2 type J9033A module 4 type J8768A module 5 type J8768A module 6 type J8768A ip default-gateway 192.168.3.2 ip routing snmp-server community "public" Unrestricted vlan 1 name "Private" untagged E1-E24,F19-F24 ip address 192.168.3.1 255.255.255.0 no untagged A1-A24,B1-B24,C1-C24,D1-D24,F1-F18 exit vlan 2 name "dmz" ip address 192.168.1.3 255.255.255.0 tagged B11-B20 exit vlan 3 name "Infraestruct" untagged A1-A2,A4-A24,B1-B20,C1-C24,D1-D24,F1-F18 ip address 192.168.10.2 255.255.255.0 tagged B21-B24 ip igmp ip irdp exit vlan 4 name "fibre" untagged A3 ip address 192.168.7.1 255.255.255.0 tagged D18 ip igmp ip irdp exit fault-finder bad-driver sensitivity high fault-finder bad-transceiver sensitivity high fault-finder bad-cable sensitivity high fault-finder too-long-cable sensitivity high fault-finder over-bandwidth sensitivity high fault-finder broadcast-storm sensitivity high fault-finder loss-of-link sensitivity high fault-finder duplex-mismatch-HDx sensitivity high fault-finder duplex-mismatch-FDx sensitivity high gvrp ip route 192.168.3.0 255.255.255.0 192.168.3.2 no ip icmp unreachable instrumentation monitor mac-moves med instrumentation monitor mac-address-count med instrumentation monitor learn-discards med instrumentation monitor pkts-to-closed-ports med instrumentation monitor ip-address-count med instrumentation monitor arp-requests med instrumentation monitor system-resource-usage med instrumentation monitor login-failures med instrumentation monitor port-auth-failures med instrumentation monitor system-delay med

What is the default gateway you have configured on your hosts that are on VLAN3 and VLAN4?

For Vlan3  192.168.10.2 and for vlan4 192.168.7.1

 

My firewall is 192.168.3.2 and all pc's connect to vlan1 have 192.168.3.x/255.255.255.0

 

 

Thank You very much.

 

If you're using those IP addresses as your default GWs, then your routing is probably working fine.

Do a tracert.

Pinging between workstations often fails due to Windows security.