Comware

Hi All 

I'm tryinig to configure IKE based IPsec following official HP configuration guide. However my 3600's don't seem to like some of the commands;

The below is directly from the guide:

# Assign an IP address to VLAN-interface 1.

 [SwitchA] interface vlan-interface 1

[SwitchA-Vlan-interface1] ip address 2.2.2.1 255.255.255.0

[SwitchA-Vlan-interface1] quit

# Define an ACL to identify data flows from Switch A to Switch B.

[SwitchA] acl number 3101

[SwitchA-acl-adv-3101] rule 0 permit ip source 2.2.2.1 0 destination 2.2.3.1 0

[SwitchA-acl-adv-3101] rule 5 permit ip source 2.2.3.1 0 destination 2.2.2.1 0

[SwitchA-acl-adv-3101] quit # Create an IPsec proposal named tran1.

[SwitchA] ipsec proposal tran1 # Specify the encapsulation mode as tunnel.

[SwitchA-ipsec-proposal-tran1] encapsulation-mode tunnel

# Specify the security protocol as ESP.

[SwitchA-ipsec-proposal-tran1] transform esp

# Specify the algorithms for the proposal.

[SwitchA-ipsec-proposal-tran1] esp encryption-algorithm aes 128

[SwitchA-ipsec-proposal-tran1] esp authentication-algorithm sha1

[SwitchA-ipsec-proposal-tran1] quit

# Configure the IKE peer

[SwitchA] ike peer peer

[SwitchA-ike-peer-peer] pre-shared-key Ab12<><>

[SwitchA-ike-peer-peer] remote-address 2.2.3.1

[SwitchA-ike-peer-peer] quit

I get to the point where I suppose to configure IKE peer but there is no such commands available. 

Is there some sort of license restriction for these? 

software on the switches is Version 5.20.99, Release 2103

Hi,
What You have in:
[SwitchA-ipsec-proposal-tran1] display version  ??