Cloud Managed Networks

 View Only

  • 1.  Import AOS-S Stack to Central

    Posted Nov 20, 2025 09:30 AM

    Hi,

    I read a lot of older posts for this topic but could not find a solution...

    I have to import about a dozen AOS-S stacks of 2930F into central, retaining the configuration. I did this for single switches and it worked just fine, of course with Template Groups only.

    However, I did not find any documentation from Aruba about importing a stack. I would presume I have to import the conductor switch first...but what then? Before saving the imported configuration, do I have to add variables for the other stack members?

    If anyone has experience with this task, I would be very happy if he/she would share.



    -------------------------------------------


  • 2.  RE: Import AOS-S Stack to Central

    Posted Nov 20, 2025 10:14 AM

    Hello @frankszo

    This topic has been discussed previously in the. You can review the discussion and access the necessary inventory through the link below. Reviewing your issue based on this inventory should resolve your issue.

    https://airheads.hpe.com/discussion/aruba-central-guide-to-using-templates-with-stacked-aos-switches

    -------------------------------------------



  • 3.  RE: Import AOS-S Stack to Central

    Posted Nov 20, 2025 10:20 AM

    Hi, 

    last reply on that thread is more than 6 years ago and ends with the same question how to import stacks retaining the configuration.

    Since the conductor already has all the config needed for VSF, does it work without any problems?

    -------------------------------------------

    Original Message


  • 4.  RE: Import AOS-S Stack to Central

    Posted Nov 20, 2025 05:30 PM

    you can refer to this start guide for AOS-S switches that covers variety of ways for configuration of AOS-S switches.

    Getting Started with AOS-S Deployments and Central.



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


  • 5.  RE: Import AOS-S Stack to Central

    Posted Nov 21, 2025 01:59 AM
    Edited by frankszo Nov 21, 2025 02:05 AM
    Thank you,
    I used that guide already when I imported an AOS-S switch to Central and kept the configuration. There is no word written about VSF stacks, so I am not sure it works.
    Too bad I do not have 2  switches for a lab test.



  • 6.  RE: Import AOS-S Stack to Central

    Posted Nov 21, 2025 06:01 PM

    when you configure your template for stack, ensure you select All in the Model drop-down, or if you select a switch model and All in the Part Number drop-down, you can apply a template to both a standalone switch and stack. 



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------

    Original Message


Related Content