Wired Intelligent Edge

 View Only

  • 1.  Interface problems in CX Switch Aruba in PnetLab

    Posted Oct 23, 2023 05:16 AM
    Edited by Greg_W Oct 23, 2023 10:07 AM

    When I add the Arubacx-10.07 image in pnetlab I only get 10 interfaces when I do a "show interface brief".

    How can I add more interfaces, is it limited? 

    Thank you very much



  • 2.  RE: Interface problems in CX Switch Aruba in PnetLab

    Posted Oct 23, 2023 10:26 AM

    Hi Adrian,

    I believe 10 is the default configured number for the interfaces. Try to stop one of your devices, click on edit and check the "ethernet" number entered. 

    I am not sure what is the limit and there is no information in release notes, so try to play around.


    Original Message


  • 3.  RE: Interface problems in CX Switch Aruba in PnetLab

    Posted Oct 23, 2023 05:56 PM

    Hi Snaydevon,

    thanks for the info, I already checked the ethernet number but no matter how much I increase the number it does not enable me more ports.

    I show the capture of the interfaces that are found as "No XCVR installed".

    any solution? Thanks.


    Original Message


  • 4.  RE: Interface problems in CX Switch Aruba in PnetLab

    Posted Oct 24, 2023 11:22 AM

    Hi Adrian,

    I think this is the current limitation of the available interfaces (10). I am not able to find any statement in the documentation, but this is the current limit (not sure when and if this is going to be changed in the future). 

    Here another old thread where this was confirmed by Vincent: https://community.arubanetworks.com/discussion/limitations-of-aos-cx-simulator

    Stanislav


    Original Message


Related Content