Comware

Hi

I have a 2650 layer three switch (J4899A) running sw version H.10.83.

I need to configure more than 8 vlans but when I try I get an error stating I have reached the maximum.

The documents I have found state it supports up to 253 vlans at the same time but when I do a "show vlan" it says maximum vlan support is only 8.

Can anyone tell me how I can get more than 8 vlans on this thing? I thought maybe it was a software thing but upgrading it to the latest version didnt cure this.

Thanks

Here is answer: http://ftp.hp.com/pub/networking/software/AdvTraff-Oct2005-59908853-Chap02-VLAN.pdf

"In the factory default state, support is enabled for up to eight VLANs. (You can
change the switch VLAN configuration to support additional VLANs. Refer to
table 2-1 on page 2-3.)"

After changing Maximum VLANs setting you must reboot the switch.