Wireless Access

 View Only
Back to discussions
Expand all | Collapse all

MSM710 controller & MSM E-430 AP different subnet

This thread has been viewed 0 times

  • 1.  MSM710 controller & MSM E-430 AP different subnet

    Posted Jun 25, 2012 08:25 AM

    Hi,

     

    Given the following scenario:

    Site1:

    MSM710 controller

    E-MSM430 AP

    controller is connected to a router

    controller resides on 10.0.24.X

     

    Site 2:

    E-MSM430 AP

    Router

    AP needs to provide addresses (via dhcp server located at site 1) the range 10.0.14.X  (different subnet than the controller's)

     

    When I'm trying to enable the dhcp server ON THE CONTROLLER (site 1) the AP fails/crashes at site 2 and in the case of static IP , AP at site 2 provides addresses at the range of 10.0.24.X.

     

    If anyone experienced something similar, it would be very helpful to provide me with some suggestions or guidance.

     

    P.S. If more info needed feel free to ask for it!

     

    Thanks

     



  • 2.  RE: MSM710 controller & MSM E-430 AP different subnet

    Posted Jun 27, 2012 06:12 AM

    Where is the access point receiving its IP address from?

     

    If you are serving addresses in the 10.0.14.* range to clients at the remote end then this is the address that wireless clients should receive - just check that the VSC is set up for authentication only and not access control



Related Content