Wired Intelligent Edge

 View Only
Back to discussions
Expand all | Collapse all

procurve 2910al lost password

This thread has been viewed 0 times

  • 1.  procurve 2910al lost password

    Posted Sep 15, 2014 12:29 PM

    I have a procurve 2910al switch that I do not have the password for. I tried the clear button on the front but it won't allow me to clear the password, guessing it's been disabled. I've tried a factory reset, deleted the boot.ini file and also loaded a new firmware on it. No luck, also tried both startup configs.

     

    any ideas on what else I can do?

     

    Thank you!


    #Passwordreset


  • 2.  RE: procurve 2910al lost password

    Posted Sep 15, 2014 03:57 PM

    Did you do the following:

     

    To execute the factory default reset on the switch, perform these steps:

    1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.

    2. Continue to press the Clear button while releasing the Reset button.

    3. When the Self Test LED begins to blink, release the Clear button.

      The switch will then complete its self test and begin operating with its configuration restored to the factory default settings.

    To restore the factory default configuration using the console, execute the erase startup-config command from the console command prompt.

     

    You will lose the current config ofcourse. If the clear/reset button has been disabled you can ask support to unlock it.



Related Content