Wireless Access

Just connect it to the same VLAN with other APs and everything will be done automatically. When you see it in GUI, , just rename it to correct name and this is it.

Assuming you are using DHCP addresses and not static addresses.

Best, Gorazd 

what is its on static ip?

means i need to console to the AP first ?

if the AP you are replacing has static IP address, just make a note of it. 

The new AP will use DHCP, so ensure you have enabled DHCP with appropriate scope, for that VLAN.

Once the new AP has joined the cluster, it might reboot to match the firmware version of the cluster, then you can configure the AP  to have the static IP address.

finally you have to reboot the new AP to ensure it is using the static IP address.

what is its on static ip?

means i need to console to the AP first ?

Just connect it to the same VLAN with other APs and everything will be done automatically. When you see it in GUI, , just rename it to correct name and this is it.

Assuming you are using DHCP addresses and not static addresses.

Best, Gorazd