Controllerless Networks

 View Only

  • 1.  Suitable Poe injector or bad setting

    Posted Apr 26, 2024 11:20 AM

    Hello, I have a question about poe. I have some IAP-315 and need to power over ethernet. Almost everything works good, but power status is 802.3af. Is it necessary to switch on/off something to get full power of APs? 

    I used poe injector U-POE-at (product list https://dl.ubnt.com/datasheets/poe/PoE_Adapters_DS.pdf) that I had in my office. Could it be caused by wrong type of injector?

    Thank for help or type of solution!



  • 2.  RE: Suitable Poe injector or bad setting

    Posted Apr 26, 2024 11:55 AM

    The 315 will run in restricted mode when powered by 802.3af and Intelligent Power Monitoring (IPM) is not enabled.  Enable IPM for the AP to operate normally under most circumstances.



    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------



  • 3.  RE: Suitable Poe injector or bad setting

    Posted Apr 26, 2024 12:22 PM
    Edited by michalkocanda Apr 26, 2024 12:30 PM

    Okay, but, where could i set IPM to enable? Is it possible thru web gui? I don't have console cable.


    Original Message


  • 4.  RE: Suitable Poe injector or bad setting

    Posted Apr 26, 2024 01:25 PM

    You need to enable IPM, not disable.

    https://www.arubanetworks.com/techdocs/Instant_810_WebHelp/Content/instant-ug/custom-iap-param/ipm.htm



    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------

    Original Message


  • 5.  RE: Suitable Poe injector or bad setting

    Posted Apr 26, 2024 02:36 PM

    Yes, that was my mistake. But how i could enable it? Is it possible without console? If not, how to use console port?


    Original Message


  • 6.  RE: Suitable Poe injector or bad setting

    Posted Apr 26, 2024 02:46 PM

    Enable Terminal Access in the Advanced Settings under Configuration > System and then SSH into the AP.

    https://www.arubanetworks.com/techdocs/Instant_810_WebHelp/Content/instant-ug/prov-iap/access-iap-cli.htm 

    Then use the information from the link Carson sent to configure and enable IPM.


    Original Message


  • 7.  RE: Suitable Poe injector or bad setting

    Posted Apr 27, 2024 04:26 AM

    perfect! it works, thank you very much


    Original Message


Related Content