Wired Intelligent Edge

I'm new to Aruba Central so sorry if this is a rudimentary question.  I've got a 6200M switch that is showing three separate  "synced with limitations" errors, on the Aruba Central dashboard.

The details of the errors say:
1. "Configuration setting removed from the device due to ['6200'] limitations with Vlan:2. Issue: Strict Version setting is not supported on the device. Supported deleting configurations for this setting is non-compatibility with SW_CX(diatype ext)"
2."Capability removed unsupported settings certificate 'aruba_defult'."
3."Capability removed unsupported settings certificate 'sys_central_nac'."

The switch appears to work fine, and configs function on the switch as expected.  But I would like to know why these "synced with limitations" errors are showing up, and how I can get rid of them? Thanks!

-------------------------------------------

Synced with limitations is not an error condition, it's more informational. They tell that something has been configured, probably on site/Global level, that is valid in itself, but can't be pushed to the specific switch model as it's not supporting that piece of configuration.

You can ignore it; blocking configuration is something that you should address. The strict version is something I've seen recently, and I'd expect to be unintentional and probably will be fixed/removed in a future version.

In case you are still worried/concerned, you may work with TAC.

------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.

In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------

Thank you very much. I actually made a TAC case last week, spoke with two separate engineers and it was referred to a third.  None of them knew why this was happening, nor what to do to fix it, nor that it need not concern me.  You are the first I've spoken with who actually knew what was going on.  It appears that Aruba support is remarkably technically inept. 

-------------------------------------------

Original Message:
Sent: Feb 23, 2026 07:14 AM
From: Herman Robers
Subject: Synced with Limitations

Synced with limitations is not an error condition, it's more informational. They tell that something has been configured, probably on site/Global level, that is valid in itself, but can't be pushed to the specific switch model as it's not supporting that piece of configuration.

You can ignore it; blocking configuration is something that you should address. The strict version is something I've seen recently, and I'd expect to be unintentional and probably will be fixed/removed in a future version.

In case you are still worried/concerned, you may work with TAC.

------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.

In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
------------------------------