There are two components to my original thoughts here:
Look through below document. Specifically the "Remote syslog commands" and the VRF parameter.
https://www.arubanetworks.com/techdocs/AOS-CX/10.10/PDF/diagnostics_83xx-10000.pdf
Also for the source interface, look for the "ip source-interface" command set
https://www.arubanetworks.com/techdocs/AOS-CX/10.07/PDF/5200-7838.pdf
------------------------------
If my post was useful, please Accept Solution and Give Kudos.
------------------------------
Zak Chalupka
Principal Engineer - HPE Aruba
ACDX | ACMP | ACSP | ACCP
wifizak@hpe.com------------------------------
Ideas expressed here are solely my own and not necessarily that of HPE Aruba.
------------------------------
Original Message:
Sent: Feb 28, 2024 12:51 PM
From: blake.crossley
Subject: Syslog and Logging - Aruba 8325 to Syslog server
Hi there
I'm just trying to get the syslogs and logging information to the syslog server. Is there a guide or anything I need to follow?
Original Message:
Sent: Feb 28, 2024 12:46 PM
From: 802.zak
Subject: Syslog and Logging - Aruba 8325 to Syslog server
Without any knowledge of your network:
Would your environment require you to specifically configure Syslog to a particular VRF and then also to a particular interface?
------------------------------
If my post was useful, please Accept Solution and Give Kudos.
------------------------------
Zak Chalupka
Principal Engineer - HPE Aruba
ACDX | ACMP | ACSP | ACCP
wifizak@hpe.com
------------------------------
Ideas expressed here are solely my own and not necessarily that of HPE Aruba.