Wired Intelligent Edge

Hi,

I've several problems with the temperature of one switch (5406zl), always is Over Temp and it's impossible to find a solution (you know.. no-ventilation, no-AirConditioner, etc.).

In conclusion... The Temp LED on Management Module is always blinking and I need to found a command to deactivate the Temp Led, change the temperature parameters or that the Switch doesn't check the temperature.

Any idea?

Many thanks in advance and greetings from Spain.

If you run the show system temp and you are also getting 9999 value, then you should get in contact with the support. Mostly after updating the FM 

Hi Patrick,

Firstly, thanks for answer. If I run sh system temperature I get the following values: 

AAPP-Planta3# sh system temperature
 System Air Temperature
     #      Current Temp Max Temp   Min Temp   Threshold   Over Temp
   -------- ------------ ---------- ---------- ----------- ----------
  + Sys-1    41C          44C        40C        40C         YES      

Yeap.. .The heat is on but the Blinking Led and the Log Alarm appear later to update the version from K.14.60 to K.15.04.0007 (It's a 5406zl). And the temperature is true, because measuring it with a real thermometer and gave me 4 degrees less.

Greetings...