Wireless Access

Hello,

I need to connect a terminal server to a HP server D390 HP-UX 10.20.

I need to know which values must be set up to the terminal server port...
Usually the following values are enough :
- Baud Rate : 9600 bps
- Data Size : 8
- Stop Bit : 1
- Parity : none
- Pace (Handshake) xon/xoff

But it seems it doesn't work this time...

Someone can help me and know how can I check the currently values set up on my server ?

Thanks,

9600-8-N-1-N

Hai

When you say terminal server, are you talking about a networked DTC?

If you are doing a modem, specifying baud rate 9600 default to 7 bit. See /etc/gettydefs for baud rates and settings.

HTH

-- Rod Hills

The 9600-8-none-1 and XON/XOFF are standard and I assume you are connecting the D390's console to the server for remote access. In most cases, you will just need a crossover cable to reverse pins 2 and 3. I keep a 9pin and a 25pin crossover adapter (aka null modem) just for this purpose. If it doesn't work with the existing cables. just insert the crossover adapter.

Oliva,

What is the make and model of the Terminal Server ?

Keith

Rodney,

Sorry I don't know what is a networked DTC ??? A terminal server is device on which you can connect a server console and so you obtain a remote access console.


Keith,

I will ask to engineer on site these informations.

Keith,

The USTS is a Cisco 2610 router.

You may wish to check out the cisco website for router setup information :-

http://www.cisco.com/en/US/products/hw/routers/ps259/prod_technical_reference09186a00800a8535.html#xtocid14

Keith