This is a short technote on using job scheduler feature of CX switches.
Job scheduler feature is pretty cool because you can run bunch of CLI commands at particular time as well as periodically. There are numerous use cases and here I'll cover three of them.
• rebooting APs periodically at specific time (in fact the approach here is about powering down POE ports irrespective of what is connected to them)
• the second one is for rebooting a switch.
• And finally schedule a reset for spanning tree statistic
Hope you'll find it useful and as always please send through your feedback for improvement.
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------