Wired Intelligent Edge

Dear

Which is the latest image for HP 5406zl???? I have the below image i want to upgrade it from where i can get latest image and which is supported image.Do we need a license to activate if we upgrade to higher version.

Switch is HP5406

Image stamp: /sw/code/build/btm(t2g)
Dec 7 2007 14:54:57
K.12.57
2415
Boot Image: Primary

Thanks.

 

 

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp forum moderator

Go to www.procurve.com and click "Support" and fill in the details of your exact switch mode, e.g.

https://h10145.www1.hp.com/downloads/SoftwareReleases.aspx?ProductNumber=J8697A〈=en&cc=us&prodSeriesId=1827663

Dear,

Do i need any License after upgrading????

Can u provide upgrading guide link??

Thanks.

mascarenhas2010 asked:
"Do i need any License after upgrading????"

No. If you already have the Premium License, then you are ok. If you need the features of the PremLic (OSPF, VRRP, Multicast routing, QinQ or IPv6 routing), that is a separate purchased license per unit.

The latest for the ProVision ASIC family (3500/5400/6200/6600/8200) is K.15.02.0005, very new! You will need to do a 2-3 step process to upgrade due to your current ROM ver level. The release notes step you through the process.

hth...Jeff

Hello Dears,

1)I have uploaded the software as a secondary image on a switch,i want to reload the switch to boot with secondary image if suppose it fails to boot,On what prompt i would be??? and what command i have to execute on that prompt such as cisco it goes in rommon mode where the commands are different than initial IOS commnands.

2)And what are the commands that will boot the switch to primary image from rommon mode.

3)I m trying to boot by K_14_49m.swi and after sucessful upgrade to K_14_49m.swi i will try to boot by K_15_02_0005.swi is it compatible with the below ROM version.

4)What is the command to see enough memmory for these images??

Software revision : K.13.51
ROM Version : K.12.14

Thanks

When i try to copy from flash to tftp server it gives me transport error???

Pls suggest.

mascarenhas2010 asked:

"1)I have uploaded the software as a secondary image on a switch,i want to reload the switch to boot with secondary image if suppose it fails to boot"

execute a 'boot system flash secondary', if it fails, the switch will reboot back to primary.


"3)I m trying to boot by K_14_49m.swi and after sucessful upgrade to K_14_49m.swi i will try to boot by K_15_02_0005.swi is it compatible with the below ROM version."

read the release notes for k.15, page 16, it says which ROM ver you need to be at.


"4)What is the command to see enough memmory for these images??"

Not an issue, memory is fixed and there is enough.

hth...Jeff

mascarenhas2010 asked:
"When i try to copy from flash to tftp server it gives me transport error?"

What is the the exact syntax you are trying?