Comware

Hi Experts,
We are in the middle of deploying NAC in our environment, we also have a lot of HP 5130 switches running,  7.1.070, Release 3208P03.
We were able to ingtegrate them successully wih the Cisco NAC solution and but, when I run the command, display dot1x connection, I see that it does not show the username?

Output:

Total connections: 1
Slot ID: 1
User MAC address: <endpoint_macaddress>
Access interface: GigabitEthernet1/0/1
Username: anonymous
User access state: Successful
Authentication domain: ciscoise
Authentication method: EAP
Initial VLAN: 230
Authorization untagged VLAN: N/A
Authorization tagged VLAN list: N/A
Authorization VSI: N/A
Authorization ACL ID: 3002
Authorization user profile: N/A
Authorization CAR: N/A
Authorization URL: N/A
Termination action: Default
Session timeout period: N/A
Online from: 2018/09/05 11:04:49
Online duration: 0h 33m 5s

Am I missing out any othe config on the switch here?
Any pointers and assistance much appreciated.

Hi,

Please provide the port configuration of GigabitEthernet1/0/1.  

Here is the interface configuration:

interface GigabitEthernetx/x/x
port link-type hybrid undo
port hybrid vlan 1 port hybrid
vlan <access vlan> untagged
port hybrid pvid vlan <access vlan>
undo voice-vlan mode auto
voice-vlan <voice vlan> enable
mac-vlan enable
undo stp enable
stp edged-port
port bridge enable
poe enable
undo dot1x handshake
dot1x handshake reply enable
dot1x mandatory-domain ciscoise
undo dot1x multicast-trigger
dot1x unicast-trigger
mac-authentication max-user 5
mac-authentication domain ciscoise
mac-authentication timer auth-delay 15
mac-authentication host-mode multi-vlan
mac-authentication parallel-with-dot1x
port-security port-mode userlogin-secure-or-mac-ext