Hello,
i am trying to setup vlans on a 1800 procurve switch like shown below:
VLAN 10 Guest -> Port 23 Fibrechannel
VLAN 20 Internal -> Port 23 Fibrechannel
VLAN 1 Default ProCurve Switch -> Port 23 Fibrechannel
VLAN 10 Guest -> Port 18
VLAN 20 Internal -> Port 18
VLAN 1 Default -> Port 18
Actually all ports are in the default vlan 1. I created the other vlans (10 and 20) and i take port 18 in the vlans and the fc port 23.
The problem is that i cant figure out how to set it up that it works like this.
I only get one of the vlans routed for port 18.
- VLAN aware is enabled for all ports
- Ingress filtering is disabled for all ports
- The packet type for all ports is all
Can you give me a example to get it work?
Thank you very much for every reply!