Wireless Access

AP325x2 on meetting room when i connect and authenticated both dot1x and captive portal it very slow and can't connect to internet

but then i walk out meeting room to connect other AP it very fast to in internet

controller : master-local , both ap325 in same local.

what happen and how can i solve this issue?

thanyou.

Do you dual link LACP these APs? If yes, try with single link.

It is not the problem with AP LACP but to ensure your swich(es) and patching pannel are wired and labeled correctly.    

---

@kts wrote:

AP325x2 on meetting room when i connect and authenticated both dot1x and captive portal it very slow and can't connect to internet

 

but then i walk out meeting room to connect other AP it very fast to in internet

controller : master-local , both ap325 in same local.

what happen and how can i solve this issue?

 

thanyou.

---

Are both of these access points using high-powered POE?

Both AP325 are connected on switch poe af/at standard.

and lacp all AP325, in same switch have other  AP325 but not have any issue. It slow and can't access to internet on sometime.

We will need more information about your setup.

- What is the output of "show ap active"?

- Do you have broadcast filtering enabled on all of your your virtual APs?

- What is the output of "show ap active"?

In red outline, 2 aps in meeting room.

- Do you have broadcast filtering enabled on all of your your virtual APs?

I have enabled all virtual ap.

---

@kts wrote:

- What is the output of "show ap active"?

In red outline, 2 aps in meeting room.

- Do you have broadcast filtering enabled on all of your your virtual APs?

I have enabled all virtual ap.

---

You have 80mhz channels enabled in your ARM profile.  In locations with any type of density, there are probably not enough channels to run 80mhz wide channels, especially combined with 40mhz channels.  You should uncheck 80 mhz channels in your RF ARM Profiles and then see if things improve.

now I disable 80Mhz and waiting for customer test. 

thankyou.

At the local controller where your AP terminates, can you post “show ap debug lacp ap-name <YOUR AP>” ?