Wireless Access

I have an old WL-410 Access Point that I need to configure and use as a bridge.

Problem is, I can't get into the configuration 'AP Manager'. It comes up with the factory IP address 153.69.254.254, but I can't get any further. It asks for a new IP address, which I assign it an address withing my internal range, then it asks for the read/write SNMP string, 'public'. When I enter that, it then comes up with, this device is not an Access Point.

Any ideas or help?

I found these instructions on the web maybe it can help you. Let me know if this helps you out in case I run into a WL-410