Comware

I replacing my procure 2910al with a Com 4800G.

 

I am just getting to grips with the command line of the 3 Com and I need to configure it to do the following.

 

I am up linking 5 procuvre 2610 with two vlans

 

data

voice

 

voice vlan is on 172.16.17.0/24

data vlan is on 192.168.2.0/24

 

PC are plugged into the Phones and pick up DHCP accordingly .

The voice vlan is tagged and the data vlan is untagged the trunk ports are tagged.

 

I have tried to do the same on the 3 com but when I tagged the trk port on the procurve vlan everything stops working.

has any one got any sample configuration for HP to 3com vlans

Also my DHCP server is going into the 3com and I cannot get the traffic from the 3com to the HP

Can you provide the relevant config from both sides of the 3Com and ProCurve?

Procurve switch

 

; J9089A Configuration Editor; Created on release #R.11.30

hostname "ProCurve Switch 2610-48-PWR" 
trunk 49-50 Trk1 LACP 
ip default-gateway 172.16.17.117 
snmp-server community "public" Unrestricted 
vlan 1 
   name "DEFAULT_VLAN" 
   untagged 1,3-48,51-Trk1 
   ip address 172.16.17.119 255.255.255.0 
   ip helper-address 172.16.17.2 
   no untagged 2 
   exit 
vlan 2 
   name "VLAN2" 
   ip address 192.168.17.119 255.255.255.0 
   ip helper-address 172.16.17.2 
   tagged 1-48,Trk1 
   exit 
vlan 3 
   name "Vlan3" 
   exit 
vlan 4 
   name "Vlan 4" 
   untagged 2 
   ip address 10.10.20.202 255.255.255.0 
   tagged 1,3-48,51-Trk1 
   voice 
   exit 
fault-finder bad-driver sensitivity high 
fault-finder bad-transceiver sensitivity high 
fault-finder bad-cable sensitivity high 
fault-finder too-long-cable sensitivity high 
fault-finder over-bandwidth sensitivity high 
fault-finder broadcast-storm sensitivity high 
fault-finder loss-of-link sensitivity high 
fault-finder duplex-mismatch-HDx sensitivity high 
fault-finder duplex-mismatch-FDx sensitivity high 
gvrp 
no stack 
spanning-tree
spanning-tree Trk1 priority 4

The ports on the 3Coms that are part of link-aggregation should probably not be stp edged-port enable

The Challenge I have is I have a Mitel 3300 plugged into both 3 coms and the phones plugged into procurve poe switches.
I cannot seem to get the Mitel traffic to the Procurves.
I untagged the ports on vlan 4 which is the voice vlan.

I am going about this the wrong way as I am trying to mirror the config from the procurves to a 3com