Dear Friends,
I have 2pcs AP555 on hand, and try to setup the Mesh connection, I started with two AP wired connected, after enable Mesh, make one AP wired disconnected, but wireless connection between APs cannot built up. I try to follow the guide below, but still failed. Anyone here can help share the setup success experience here or some intutive guide to setup Mesh network? Thanks a lot.
Mesh
| Arubanetworks |
remove preview |
|
| Mesh |
| Chapter 7 Secure Enterprise Mesh The Arubasecure enterprise mesh solution is an effective way to expand network coverage for outdoor and indoor enterprise environments without any wires. Using mesh, you can bridge multiple Ethernet LANs or you can extend your wireless coverage. As traffic traverses across mesh APs, the mesh network automatically reconfigures around broken or blocked paths. |
| View this on Arubanetworks > |
|
|
Configuring Mesh Cluster Profiles
| Arubanetworks |
remove preview |
|
| Configuring Mesh Cluster Profiles |
| The mesh cluster configuration gets pushed from the controller to the mesh portal and the other mesh points, which allows them to inherit the characteristics of the mesh cluster of which they are a member. Mesh nodes are grouped according to a mesh cluster profile that contains the MSSID, authentication methods, security credentials, and cluster priority. |
| View this on Arubanetworks > |
|
|
.
Configuring Mesh Instant AP
| Arubanetworks |
remove preview |
|
| Configuring Mesh Instant AP |
| Aruba Central Online Help The mesh solution effectively expands and configures network coverage for outdoor and indoor enterprises in a wireless environment. The mesh network automatically reconfigures broken or blocked paths when traffic traverses across mesh Instant AP. |
| View this on Arubanetworks > |
|
|
Hogan
------------------------------
hogan weng
------------------------------