Comware

 View Only
Expand all | Collapse all

Creating Link aggregation between 2 switches using LACP

This thread has been viewed 0 times
  • 1.  Creating Link aggregation between 2 switches using LACP

    Posted May 31, 2010 04:56 AM
    is there any configuration changes on the switches configuration when creating LACP trunk between 2 switches using wireless bridges ?



  • 2.  RE: Creating Link aggregation between 2 switches using LACP

    Posted Jun 01, 2010 01:31 AM
    Hi Shadow13,

    not necessarily. But I would recommend to enable UniDirectional Link Detection (UDLD - "link-keepalive"), since you will not physically detect a link loss on the switch port, when the wireless signal gets stuck.

    Regards,
    Ralf