Comware

Hello!

I have a J4812A#ABB PROCURVE SWITCH 2512 and I inserted a gigabit-tranciever (J4132A) while it
was powered on.

The hardware counters seem to have gotten messed up (look below), is there any way to reset them?

Regards Erik Kjellin / Port80 AB

sergel 14-May-2003 22:03:23
02=========================- TELNET - MANAGER MODE -============================
Status and Counters - Port Counters - Port 14


Name :


Link Status : Down


Bytes Rx : 4,294,967,231 Bytes Tx : 4,294,967,231
Unicast Rx : 4,294,967,295 Unicast Tx : 4,294,967,295
Bcast/Mcast Rx : 4,294,967,294 Bcast/Mcast Tx : 4,294,967,294


FCS Rx : 4,294,967,295 Drops Tx : 0
Alignment Rx : 0 Collisions Tx : 0
Runts Rx : 4,294,967,295 Late Colln Tx : 0
Giants Rx : 4,294,967,294 Excessive Colln : 0
Total Rx Errors : 4,294,967,292 Deferred Tx : 0



Actions-> Back Reset Help

Did you use
clear statistics [ethernet] <PORT list=""> ?
RGDS
J</PORT>

Yes, but that would have the same effect as clearing
the counters via the menues. This would only be temporary.
Once a new console session is initiated, the counters will
revert back to the values maintained by the switch hardware.

"I'm afraid" then you'd have to re-load basic configuration from ROM, to reset all parameters...