Comware

Hello everyone

I have a very old HP 3com switch 4800G, which still runs with no problems but the time has come to replace it. The switch has a VRRP configured for VLAN1. Does anyone know the syntax for removing it, please? I did have a look at the CLI reference for 3com online but I could only find the syntax to create a VRRP, couldn't see anything for removing it. Please see below 

[3com]show vrrp

IPv4 Standby Information:

Run Method      : VIRTUAL-MAC             

Total number of virtual routers: 1

Interface          VRID  State       Run     Adver.  Auth     Virtual

                                      Pri     Time    Type        IP 

---------------------------------------------------------------------

Vlan1                1   Backup      110     1       SIMPLE   10.84.100.200       

--------------------------------------------------------------------

How can I remove the above VRRP entry?

Thank you

Kabamaru

Hi, for a comware device the VRRP is configured in the SVI (vlan interface).

So something like

sys

interface vlan 1

undo vrrp .....  (undo each vrrp command under the stanza)

Thanks a lot Ian.

That worked.